Switching between com1 and com2 not working

Support Pilot Software
1

Hi,

According the documentation, I can switch com1 and com2 using .tx. In my case it’s not working.

I’m using X-Plane 12 on a Mac with M2 processor. Already re-installed xPilot, with no succes?

Any suggestions?

Kind regards,
Brenny

2

Hi Brenny, you might want to tag your post with xpilot instead of vpilot.

3

You are right. Thank you.

4

I’m going to answer my own question.

My problem is related to the Zibo B738. Controlling the COM selection on xPilot using the Zibo radio stack is the solution. To be particular: the Mic selection part in the radio stack for tx and the buttons immediately below that for rx. Assigning hot keys will make switching a peace of cake.