Sweatbox: Transfer Simulation between two Manager doesn't work

Support Controller Software
1

Good morning,
I’m trying to create a scenario where traffic is shared between two “Sweatbox Managers.” I have two scenario files: one for landing traffic and VFR traffic patterns, and one for ground traffic. After landing, the traffic should be handed over to the Ground Sweatbox Manager (Transfer Simulation). The handover only works partially: the Ground Manager is shown as having control (yellow asterisk), but he cannot move the aircraft on the ground. The “Ground Simulator Ribbon” can be selected, but the other buttons, such as “New,” cannot be pressed.

Conversely, departing aircraft can be handed over from the Ground Manager to the Flight Manager and controlled by the latter (speed, heading, altitude, etc.).

Can anyone help solve this problem?

2

Please check if both managers have the simulation data pubilsh set:
image

Do not set it “To everyone” as it might overload Sweatbox.

Another thought: Why do you need to split the scenrio file. You may run the whole session in a single engine and use the other station as pseudo pilot position only.

3

Thanks, it works. Finally. :partying_face:

You mean I can run the entire simulation on my computer and the other managers log into the sweatbox and then control the planes?