Hi, I had some sound issues with X Pilot (ATC did not hear me). So I up dated the driver of my microphone (Logitech camera) and uninstalled X Pilot and installed it again.
When ATC did not hear me again today, I went to SETTING and opened the SOUND part and on the right side the slider to regulate ws visible but the bar above which is green when microphone is set correctly and gets red when it is too loud was not visible at all!
So I disconnected and reconnected, after this this bar was visible again and ATC could hear me.
Wondering if it is a technical issue on X Pilot side. The sound tab of windows/sound is working all the time correctly, just the X Pilot sound tab (the one which is green/blue/red to measure if the sound slider is set correctly) has a pb…
Anybody else had this issue? Anybody has an advice?
EDIT:
I FOUND THE ISSUE, IT WAS THE MIC USB CABLE WHICH WAS A BIT LOOSE…
Thanks!!